@article { author = {PadashtDehkaei, Fereidoon and Okhovat, SeyedMahmoud and JavanNikkhah, Mohammad and Mahmoudi, Seyed Bagher}, title = {Optimization of Inoculation Method in Sheath Blight Disease to Detect Rice Cultivars Actual Reactions in the Field}, journal = {Iranian Journal of Plant Protection Science}, volume = {40}, number = {2}, pages = {-}, year = {2010}, publisher = {University of Tehran}, issn = {2008-4781}, eissn = {2423-7868}, doi = {}, abstract = {Sheath blight disease, caused by Rhizoctonia solani AG-1 IA, is one of the most serious fungal diseases of rice, worldwide. Rice resistance is a relative phenomenon and disease response varied (due to complex quantitative inheritance and high environmental diversity), so an accurate disease assessment would be difficult. To detect a reliable reaction of rice in a high level of disease development, a new inoculation method was developed, using Mycelial Mass (MM) of R. solani, produced in PD-broth along with application of a water sprayer system. Seedlings from three local and from two improved cultivars (Anbarbo, Ghasroldashti, Ahlemi-Tarom, Khazar and Bahar, respectively) were transplanted into the field. After 45 days past, tillers from each plant were sealed using rubber bands, then inoculated by a virulent isolate of pathogen, in three methods of: mycelial mass, colonized Rice Grain/rice hull (RG) and Freshly Infected rice stem (FI). Inoculated plants were kept moist until the last scoring time by through of a water sprayer system, above the tested plants in the field. Disease scoring was recorded 15 and 25 days following inoculation and at the end of dough grain stage, using the Relative Lesion Height (%RLH) method. Detailed disease assessment introduced the FI method as appearing with a low level of disease development, and of highly varied results. But MM and RG methods were of less varied results within each cultivar and at different times of evaluation. The most conspicuous vertical disease development was observed (among all tested cultivars) at the second evaluation stage and at the end of dough stage (the most susceptible stage of rice growth) in the MM inoculation method. Therefore, the plants were divided into three and two groups, respectively, and were found different from grouping by RG and FI methods (DMRT 5%). Therefore under water sprayer system, MM inoculation method can be used for the measurement of rice reliable reaction to sheath blight disease in the field. Anbarbo, Ghasroldashti, Ahlemi-Tarom and Bahar were identified as moderately resistant with the same statistical group from first screening test, but in this study they fell in different groups and their reliable tolerance were appeared after optimization of the test condition by development of disease, so Ahlemi-Tarom showed very susceptible reaction.}, keywords = {inoculation,Inoculum,isolation,purification,Rhizoctonia solani,Rice sheath blight,Tanatephorus cucumeris.}, title_fa = {بهینه‌سازی روش‌ آلوده‌سازی در بیماری سوختگی غلاف به منظور تفکیک واکنش‌های واقعی ارقام برنج در مزرعه}, abstract_fa = {بیماری سوختگی غلاف برنج که در اثر گروه آناستوموزی AG1-IA از قارچRhizoctonia solani به وجود می‌آید، یکی از مهمترین بیماری‌های قارچی برنج در دنیا می‌باشد. مقاومت گیاه برنج نسبی است و عکس‌العمل آن در مقابل این بیماری به دلیل پیچیدگی توارثی‌ و ناپایداری محیطی ثابت نیست به‌طوریکه تخمین صحیح بیماری مشکل است. برای تشخیص واکنش واقعی برنج در سطح بالایی از توسعه بیماری، یک روش آلوده‌سازی جدید، با تولید توده میسلیومی در محیط کشت مایع سیب‌زمینی دکستروز (PDBroth) و یک سیستم افشانه آب، طراحی گردید. نشاهای برنج از سه رقم بومی (عنبربو ‌ایلام، قصرالدشتی و اهلمی‌ طارم) و دو رقم اصلاح شده (خزر و بهار) در مزرعه نشاکاری گردیدند. پس از 45 روز پنجه‌های هر بوته به کمک یک باند پلاستیکی بسته شدند، سپس با یک جدایه پرآزار بیمارگر و به سه روش شامل، توده میسلیومی (MM)، مخلوط بذر و پوسته برنج کلنیزه شده(RG) و قطعات ساقه تازه آلوده شده برنج(FI) آلوده‌سازی شدند. بوته‌های آلوده‌سازی شده با راه‌اندازی یک سیستم افشانه آب در بالای بوته‌ها و در ارتفاع 160 سانتی‌متری از سطح خاک تا آخرین مرحله ارزیابی، مرطوب نگه داشته شدند. میزان توسعه بیماری 15 و 25 روز پس از آلوده‌سازی و انتهای مرحله خمیری شدن دانه به روش RLH (Relative Lesion Height) اندازه‌گیری گردید. سنجش داده‌های بیماری نشان داد که در روش آلوده‌سازی FI بیماری با توسعه کم و با نتایج بسیار متغیر ظاهر شد. اما نتایج در روش‌های آلوده‌سازی MM و RG دارای تغییرات کمتری در بین ارقام در مراحل مختلف ارزیابی بودند. بیشترین توسعه عمودی بیماری در همه ارقام مورد آزمایش در دومین مرحله ارزیابی و انتهای مرحله خمیری شدن دانه (حساس‌ترین مرحله رشدی برنج) در روش MM مشاهده شد. به‌طوریکه آنها به‌ترتیب در سه و دو گروه قرار گرفتند که متفاوت از گروه بندی در روش‌های RG و FI بودند (DMRT 5%). بنابراین در شرایط استفاده از سیستم افشانه آب، آلوده‌سازی به روش توده میسلیومی را می‌توان برای سنجش عکس‌العمل واقعی ارقام برنج در مقابل بیماری سوختگی غلاف در مزرعه به کار گرفت. ارقام عنبربو، قصرالدشتی، اهلمی طارم و بهار در آزمایش غربال‌گیری اولیه به‌عنوان ارقام نیمه مقاوم در یک گروه آماری مشابه تشخیص داده شدند، اما در این مطالعه آنها در گروه‌های متفاوتی قرار گرفتند و تحمل واقعی آنها بعد از بهینه‌سازی شرایط آزمایش و با توسعه بیماری ظاهر شد به‌طوریکه اهلمی طارم به‌شدت حساسیت نشان داد.}, keywords_fa = {جداسازی,خالص‌سازی,زادمایه,سوختگی غلاف برنج,مایه‌زنی}, url = {https://ijpps.ut.ac.ir/article_20676.html}, eprint = {https://ijpps.ut.ac.ir/article_20676_ea8d7e8721c570a3391e7b549c6e406e.pdf} }